澳门金牛版免费-澳门六网金牛版-澳门六下彩资料金牛版

Product list
HOTLINE

澳门金牛版免费-澳门六网金牛版-澳门六下彩资料金牛版0577-65130099

News

Current Location:Home》News

Control mode and pipe arrangement of pneumatic motor
Release time:2018-1-11 13:28:00 Source:

澳门金牛版免费-澳门六网金牛版-澳门六下彩资料金牛版 The pneumatic motor is divided into two forms, one way and two ways. The rotation and stop of the motor can be controlled by only opening and closing the intake air inlet of the unidirectional pneumatic motor.

澳门金牛版免费-澳门六网金牛版-澳门六下彩资料金牛版 The two-way pneumatic motor has two air intake and one main exhaust port. When the motor enters the intake port from one intake port, the other intake port is the secondary exhaust port. If the motor rotation direction changes, only the exchange port between the intake port and the secondary exhaust port can be changed, so the selected control valve must have the above functions to make the motor work normally. It is recommended to choose three four - way valves or three - position five - way valves. When piping is arranged, the pipeline diameter between the gas source and the gas motor, including pipe fittings, control valves, oil mist sprayer, etc., shall not be less than the minimum inner diameter suitable for the motor, and there is no serious throttling phenomenon for the pipeline. The pipe joint should be firmly, sealed and no leakage, otherwise the pneumatic motor can not reach its working performance.

重庆时时全天在线计划-重庆时时全天计划官网-重庆时时开彩结果 澳门金牛版免费-澳门六网金牛版-澳门六下彩资料金牛版 澳门金牛版免费-澳门六网金牛版-澳门六下彩资料金牛版 澳门金牛版免费-澳门六网金牛版-澳门六下彩资料金牛版 澳门金牛版免费-澳门六网金牛版-澳门六下彩资料金牛版 澳门金牛版免费-澳门六网金牛版-澳门六下彩资料金牛版